ShoreLand'r SLR10TS - Manual (Page 9)

Once the winch post is set secure the winch post to the tongue
with the three mounting bolts used to attach it to the tongue.
The axle is not adjustable on this model trailer. To change the
tongue will require you to place the additional gear in the boat
in the correct location. Moving the added weight forward or
backward will change the tongue weight.
A recommended tongue weight for your trailer is 7-10% of the
total load including boat, motor, and trailer.
Adjustments are now complete. Double check your boat for fit.
If desired fit has been achieved, tighten all fasteners that may
have either been left loose or have been loosened to do the
adjusting.
Note: All nuts and bolts must be tightened before towing.
The law requires that the white ground wire on both the tongue
wire harness and vehicle harness be properly grounded to
respective trailer and vehicle frames.
Re-check all fasteners on the complete trailer to make sure
they are all tight and ready for towing. All fasteners should be
periodically check before towing.
See your ShoreLand’r Owner’s Guide for further technical
information regarding your trailer and its components.
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0003276
Page 9 of 9 Rev B 4/15/2011