ShoreLand'r SLB46TBBS V.1 - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003466
Page 9
den stop. It can be moved up or down by removing the back bolt
that mounts the winch head to the base. When this bolt is removed,
the head can be rotated up or down to reach the desired height re-
quired to fit your boat. Once in this position, align the closest pair of
holes in the brackets and reinsert the bolt just removed. Tighten.
Attach the winch strap and crank winch tight. Attach the bow eye
safety chain into the bow eye of the boat as well. This is just an-
other level of protection to keep your boat and trailer together as
one unit.
Adjustments are now complete. Double check your boat for fit. If the
desired fit has been achieved, tighten all fasteners that may have
either been left loose or have been loosened to do the adjusting.
Note: All nuts and bolts must be tightened before towing. The law
requires that the white ground wire on both the tongue wire harness
and vehicle harness be properly grounded to respective trailer and
vehicle frames.
Recheck all fasteners on the complete trailer to make sure they are
all tight and ready for towing. All fasteners should be periodically
checked before towing.
See your ShoreLand’r Owner’s Guide for further technical infor-
mation regarding your trailer and its components.
�
�
�
��
��
��
���
�
��������������������������������������������������������