ShoreLand'r SLB46TBAL - Manual (Page 2)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M303105
Page 2
FINAL ASSEMBLY INSTRUCTIONS
remove the grommets in the side frame and place the extra wire in the
side frame. Replace grommets.
White Ground Wire Installation
Place the self-tapping screw provided through the round metal ring on
the white ground wire of the tongue harness located at the rear of the
tongue. Attach the ground wire to the main frame by driving the screw
in the hole provided next to the tongue channel of the frame. This will
assure a positive ground for the lighting.
Locate the brass brake line coupling. Remove the plastic cap and thread
the brake line coming out the rear of the tongue into one end of the
coupling. Bend the line in a smooth gradual radius being careful not to Remove the hardware bag from the frame, remove
parts and sort by size.
IMPORTANT: All hardware is stainless steel. Use
an anti-seize material on bolt threads when
assembling toprevent gaulding.
TONGUE
The tongue comes shipped positioned backwards
in the frame.
Remove the nut and bolt that holds the tongue in
place and discard. Remove the tongue from its ship
position and install correctly in the front tongue
channel.
Line the holes in the tongue with the holes in the
tongue channel. Install the 1/2” x 4” hex bolt in the
front cross hole and secure with a 1/2” lock nut.
Remove the wire harness from the rear of the
tongue. Place the wire harness and the brake line
through the hole provided in the tongue cover plate.
(See Detail J).
Secure the tongue cover plate with the same 1/2” x
1-1/2” hex bolt that secures the back on the tongue
to the tongue channel of the frame. Secure with a
1/2” lock nut. Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame
harnesses by matching colors and ends. Push the
extra wire either into the rear of the tongue or
kink the line. Bend the line so it can be mated to the brake line from the
side frame. Once aligned thread the side frame brake line into the
other end of the coupling. Tighten both lines into the coupling.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a 1/2” flat washer
and through the last link of one of the safety chains.
Place the bolt with chain attached through the hole in the bottom front
of the actuator mounted on the tongue. Place the second chain on the
the bolt threads extending through the other side of the tongue. Place
on another 1/2” flat washer and hex lock nut. Tighten.