ShoreLand'r SLB40TCBLW - Manual (Page 8)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004262
Page 8 of 15 9/23/2010
DUAL AXLE BRAKE INSTALLATION
If your trailer is equipped with dual axle brakes con-
nect the line to the axle as follows:
Cut the tape securing the brake line hose in the axle.
Remove the plastic plug from the bottom port in the
brass block on both brake calipers. Thread the brake
hose male end into the block and tighten to either 6-
8 ft. lb. or 72-96 in. lb. of torque.
DO NOT OVER TIGHTEN
Over tightening will cause the brass block to crack
and or the threads to release and then leak.
Attach the brake hose from the attaching kit to the
side port on the brass block on the right side of the
rear axle and then to the spring bracket with the U-
shaped hose clip. Once the brake hose is secured in
place, locate the brass tee connector. Screw the
male port of the tee into the brake line hose. Tighten.
Next connect the side frame brake line hose into the
top port on the tee. Connect the two axles together
using the 42” brake line hose supplied. Thread one
end of the line into the brass tee just installed. Route
the line over to the other axle, forming a loop in the
line thru the clip on the spring bracket and then
connect the other end into the brake caliper on the
second axle. Tighten to either 6-8 ft. lb. or 72-96 in.
lb. of torque. Using the clamps and screws included
in the kit secure the hose to the sideframe to keep it
protected from damage.
DO NOT OVER TIGHTEN
Over tightening will cause the brass block to crack
and then leak.
NOTE: The complete brake system including the
axle MUST be re-bled to ensure that all air has been
removed from the brake system.
For bleeding instructions see the UFP brake bleeding
manual or the ShoreLand’r Disc Brake Manual.
Fill the actuator reservoir with brake fluid and bleed
the line per the instructions in the Brake Manual.
TIRE & WHEEL ASSEMBLY
Mount the tire and wheel assemblies using the 1/2”
fine threaded tapered lug nuts provided. Tighten to
85-95 ft./lb. torque using the rotation pattern as shown
in the ShoreLandr’s Owners Manual. Re-torque the
lug nuts after 50 miles driving and then periodically
thereafter.
Tire Size and Carrying Capacity Chart
Tire Size..............................ST215/78R14-C
GVWR...................................5440 lb.
Carrying Capacity...............4000 lb.
Axle.......................................Disc Brakes
Refer to the tire side wall for correct tire pressure.