ShoreLand'r SLB40TCBLW - Manual (Page 13)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004262
Page 13 of 15 9/23/2010
B-SERIES BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the bunk
mounting brackets are assembled to the bunks at the
factory. Place the end with the two brackets towards the
rear of the trailer. Place the assembly on the equiload bunk
arm and secure by placing a 3/8” x 1” hex bolt through the
bracket on the bunk and the ear on the end of the equiload
arm. Secure in place using a 3/8” lock nut. Repeat on the
other end of the arm. (See Diagram A).
Place the other end of the bunk in the bracket installed on
the front cross member. Note that this bracket is not
attached to the bunk because the trailer can be adjusted to
two different lengths.
Once the proper position for the rear cross member is
determined, the front of the bunk can now be attached to
the bracket using two- No. 10 x 1-1/4” self tapping screws
as shown in Detail B.
The 3/8” x 1” bolts attaching the bunks to the equiload arms
and front bunk bracket can be tightened but not over
tightened. The bunks must be allowed to rotate slightly to
conform to the boat bottom once the boat is set on the
trailer.