ShoreLand'r SLB40TBXLW - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003457
Page 3
FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame, remove
parts and sort by size.
B-SERIES BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the
bunk mounting brackets are assembled to the bunks
at the factory. Place the end with the two brackets to-
wards the rear of the trailer. Place the assembly on the
equiload bunk arm and secure by placing a 3/8” x 1”
hex bolt through the bracket on the bunk and the ear
on the end of the equiload arm.Secure in place using
a 3/8” lock nut. Repeat on the other end of the arm.
(See Diagram A).
Place the other end of the bunk in the bracket installed
on the front cross member. Note that this bracket is
not attached to the bunk because the trailer can be
adjusted to two different lengths.
Once the proper position for the rear cross member is
determined, the front of the bunk can now be attached
to the bracket using two- No. 10 x 1-1/4” self tapping
screws as shown in Detail B.
The 3/8” x 1” bolts attaching the bunks to the equiload
arms and front bunk bracket can be tightened but not
over tightened. The bunks must be allowed to rotate
slightly to conform to the boat bottom once the boat is
set on the trailer.