ShoreLand'r SLB22L V.2 - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0003696
Page 9 of 10 Rev A 4/26/2011
BUNK ASSEMBLY (B-SERIES)
The 2 x 4 bunk assemblies have the bunk brackets factory as-
sembled. Place the end of the bunk with the two brackets on
the equiload bunk arm. (See Detail D) Secure with 3/8” x 1”
hex bolts and lock nuts through the brackets on the bunk and
the ear on each end of the equiload arm.
Place the other end of the bunk in the bracket mounted on the
front cross member. (The bracket is adjustable for height as
well as side ways.) Once the proper position for the rear cross
member is determined, the front of the bunk can be attached
to the bracket using two No. 10 x 1-1/4” self tapping screws as
shown in Detail E. Repeat assembly on the other bunk.
The 3/8” bolts can be tightened, but do not over tighten. The
bunks must rotate slightly to conform to the boat bottom.
See Page 10 for final adjustments.