ShoreLand'r SLB22L V.2 User Manual
Page 4

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028
www.shorelandr.com
0003696
Page
4
of
10
Rev
A
4/26/2011
WIRE HARNESS  
Locate the wire harness. Push the two triangular plugs in the hole 
on the top of the tongue, then out the rear of the tongue. Place the 
wire harness through the hole in the tongue cover plate. (See 
Detail A) Secure the tongue cover plate in position with a 1/2” X 1-
1/2” hex bolt and 1/2” lock nut. Tighten. Plug the tongue wire 
harness ends into the frame harnesses by matching colors and 
ends. Push the extra wire into the rear of the tongue or remove the 
grommets in the side frame and place the extra wire in the side 
frame. Replace grommets just removed. 
 
Winch Post 
Place the winch post assembly on the tongue and secure with 
three 3/8” X 4” hex bolts and hex flange lock nuts. Place the nuts 
on the bolts but do not tighten because they will have to be 
readjusted once the boat is on the trailer 
. 
Remove the winch handle nut from the shaft. Align the hole in the 
winch handle with the flat surfaces on the shaft. Slide in position 
and secure with the nut just removed. Tighten.
TONGUE  
The tongue comes shipped separate of the frame. Locate and 
slide the tongue in the front tongue channel. Line the holes in 
the tongue with the holes in the tongue channel. Secure with a 
1/2” X 4” hex bolt and 1/2” lock nut in the front cross hole. 
 
Locate the coupler bag. Place the coupler on the end of the 
tongue, align holes and secure with one 1/2” X 4” hex bolts and 
hex flange lock nuts in the rear coupler hole. Place two 1/2” X 1” 
hex bolts into the front holes of the coupler and secure to the 
each side of the tongue with 1/2” flange lock nuts. Tighten. 
 
SAFETY CHAINS  
Mount the safety chains to the front of the tongue by placing a 
3/8” flat washer onto a 3/8” X 1-1/4” hex bolt, then insert the bolt 
through the last link of the safety chain. Put the bolt through the 
hole on one side of the tongue as shown. Place on another flat 
washer and secure with a 3/8” hex flange nut. Tighten. Repeat 
on the other chain on the other side of the tongue.
