ShoreLand'r SLB18LN V.2 - Manual (Page 10)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003693
Page 10 11/02/06
BUNK ASSEMBLY (B-SERIES)
The 2 x 4 bunk assemblies have the bunk brackets factory as-
sembled. Place the end of the bunk with the two brackets on the
equiload bunk arm. (See Detail D) Secure with 3/8” x 1” hex bolts
and lock nuts through the brackets on the bunk and the ear on each
end of the equiload arm.
Place the other end of the bunk in the bracket mounted on the
front cross member. (The bracket is adjustable for height as well
as side ways.) Once the proper position for the rear cross member
is determined, the front of the bunk can be attached to the bracket
using two No. 10 x 1-1/4” self tapping screws as shown in Detail E.
Repeat assembly on the other bunk.
The 3/8” bolts can be tightened, but do not over tighten. The bunks
must rotate slightly to conform to the boat bottom.
See Page 10 for final adjustments.