Slb18n – ShoreLand'r SL18LN User Manual
Page 5
Midwest Industries, Inc.
Ida Grove, IA 51445
(800)859-3028
www.shorelandr.com
M304285
REV A 9/18/03
Page 5
BUNK ASSEMBLY (B-SERIES)
The 2 x 4 bunk assemblies have the bunk brackets
factory assembled. Place the end of the bunk with the two
brackets on the equiload bunk arm. (See Detail H) Secure
with 3/8” x 1” hex bolts and lock nuts through the brackets on
the bunk and the ear on each end of the equiload arm.
Place the other end of the bunk in the bracket mounted on
the front cross member. (The bracket is adjustable for height
as well as side ways.) Once the proper position for the rear
cross member is determined, the front of the bunk can be
attached to the bracket using two No. 10 x 1-1/4” self tapping
screws as shown in Detail I. Repeat assembly on the other
bunk.
The 3/8” bolts can be tightened, but do not over tighten. The
bunks must rotate slightly to conform to the boat bottom.
See Page 8 for final adjustments.
SLB18N