ShoreLand'r SL18LN - Manual (Page 2)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M304285
REV A 9/18/03
Page 2
ASSEMBLY INSTRUCTIONS
Remove all items from the frame. Locate the hardware bag and
sort all items by size.
Locate the coupler bag. Pace the coupler on the end
of the tongue, align holes and secure with two 1/2” X
4” hex bolts and hex flange lock nuts. Tighten.
WIRE HARNESS
Locate the wire harness. Push the two double plugs
in the hole on the top of the tongue, then out the rear
of the tongue. Place the wire harness through the hole
in the tongue cover plate. (See Detail B) Secure the
tongue cover plate in position with a 1/2” X 1-1/2” hex
bolt and 1/2” lock nut. Tighten. Plug the tongue wire
harness ends into the frame harnesses by matching
colors and ends. Push the extra wire into the rear of
the tongue or remove the grommets in the side frame
and place the extra wire in the side frame. Replace
grommets just removed.
TONGUE
The tongue comes shipped incorrectly in the frame. Slide the tongue
out from it’s shipping position and reinstall in the front tongue
channel. Line the holes in the tongue with the holes in the tongue
channel. Secure with a 1/2” X 4” hex bolt and 1/2” lock nut in the
front cross hole.