ShoreLand'r SL46TBAL - Manual (Page 2)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003629
Page 2 3/09/06
FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame, re-
move parts and sort by size.
IMPORTANT: All hardware is stainless steel.
Use an anti-seize material on bolt threads when
assembling to prevent gaulding.
TONGUE
The tongue comes shipped positioned backwards
in the frame.
Remove the nut and bolt that holds the tongue in
place and discard. Remove the tongue from its
ship position and install correctly in the front tongue
channel.
Line the holes in the tongue with the holes in the
tongue channel. Install the 1/2” x 4” hex bolt in the
front cross hole and secure with a 1/2” lock nut.
Remove the wire harness from the rear of
the tongue. Place the wire harness and
the brake line through the hole provided in
the tongue cover plate. (See Detail J).
Secure the tongue cover plate with the
same 1/2” x 1-1/2” hex bolt that secures the
back on the tongue to the tongue channel of the frame. Se-
cure with a 1/2” lock nut. Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame harnesses by match-
ing colors and ends. Push the extra wire either into the rear of the tongue
or remove the grommets in the side frame and place the extra wire in
the side frame. Replace grommets.