ShoreLand'r LEB22CSW V.3 - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003283
Page 5 REV C 12/19/06
TONGUE
The tongue is shipped separate from the frame. Locate the ap-
propriate tongue and install by sliding it in the front of the tongue
channel.
Line the holes in the tongue with the holes in the tongue
channel. Install the 1/2” x 4” hex bolt in the front cross hole and
secure with a /2” lock nut.
Remove the wire harness from the rear of the tongue. Place the
wire harness and the brake line (If equipped with brakes)
through the hole provided in the tongue cover plate.
Secure the tongue cover plate in position with the same 1/2” x
1-1/2” hex bolt that secures the back on the tongue to the
tongue channel of the frame. Secure with a /2” lock nut.
Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame harnesses by
matching colors and ends. Push the extra wire provided either
into the rear of the tongue or else remove the grommets in the
side frames and place the extra wire in the side frames. Replace
grommet just removed.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a 1/2”
flat washer, then place through the last link of one of the
safety chains.
Place the bolt with chain attached through the hole
provided in the bottom front of the actuator mount on the
tongue. Place the second chain on the portion of the bolt
extending through the other side of the tongue. Place on
another 1/2” flat washer and hex lock nut. Tighten.
SPARE TIRE BRACKET
The first step in mounting the spare tire bracket is to determine
the correct orientation of the trailer. Standing at the rear of the
trailer and looking forward, your right hand is the right-hand side
of the trailer.
Mount the spare tire bracket on the right-hand side frame of your
trailer at a location somewhere between the very front of the frame
and the first cross member. The exact positioning is dependant
upon the size and style of your boat.
Once identified, attach the spare tire bracket to the side frame us-
ing the U-bolts provided in the kit. Note that the spare tire bracket
is designed to fit both 2” x 4” and 2” x 5” side frames. Use the 1/2”
x 4-9/16” x 3-1/2” U-bolt when mounting to the 2” x 4” side frame
and the 1/2” x 5-9/16” x 3” U-bolts when mounting to the 2” x 5”
side frame.
Place the U-bolts over the side frame in the desired location. Match
the holes in the spare tire bracket with the U-bolts just placed over
the side frame. Slide the spare tire bracket over the U-bolts. Secure
using 1/2” lockwashers and hex nuts. Tighten when desired loca-
tion is achieved.
The spare tire bracket is designed to fit a 5 bolt on 4.5” bolt circle
pattern wheel. Note that there are only three stud bolts in the spare
tire bracket which are sufficient to carry the tire and wheel assem-
bly. Align the three studs with the holes in the wheel assembly and
secure the wheel assembly to the spare tire bracket with three- /2”
tapered lug nuts provided in the kit. Tighten securely to make sure
the wheel assembly does not come loose and fall off while trans-
porting the trailer.
Installation is complete.