HEIDENHAIN TNC 640 (34059x-02) ISO programming - Manual (Page 466)

Manual operation and setup
15.6 Using 3-D touch probes
15
466
TNC 640 | User's Manual for DIN/ISO Programming | 5/2013
15.6 Using 3-D touch probes
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function Soft key Page
Calibrating the effective length 475
Calibrating the effective radius 476
Measuring a basic rotation using a
line
480
Setting a datum in any axis 482
Setting a corner as datum 483
Setting a circle center as datum 485
Setting the centerline as datum 487
Touch probe system data
management
See User’s
Manual for
Cycles
You can also use all manual touch probe cycles,
except the corner probing cycle, in Turning mode.
Observe that in Turning mode all measured data
in the X coordinate are calculated and displayed as
diameter values.
To use the touch probe in Turning mode you should
separately calibrate the touch probe in Turning mode.
Because the basic setting of the turning spindle in
Milling mode and Turning mode may deviate, you
should calibrate the touch probe without center
offset. You can create additional tool data for this
purpose, e.g. as an indexed tool.