14 manual operation and setup, Programming: pallet editor – HEIDENHAIN iTNC 530 (606 42x-01) User Manual
Page 37
HEIDENHAIN iTNC 530
37
14.1 Switch-On, Switch-Off ..... 516
14.2 Moving the Machine Axes ..... 520
Moving the axis using the machine axis direction buttons ..... 520
Incremental jog positioning ..... 521
Traversing with electronic handwheels ..... 522
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 532
Changing the spindle speed and feed rate ..... 533
14.4 Functional Safety FS (Option) ..... 534
Explanation of terms ..... 535
Check axis positions ..... 536
Overview of permitted feed rates and speeds ..... 537
Activating feed-rate limitation ..... 538
Additional Status displays ..... 538
14.5 Datum Setting without a 3-D Touch Probe ..... 539
Workpiece presetting with axis keys ..... 540
Datum management with the preset table ..... 541
14.6 Using the 3-D Touch Probe ..... 548
Selecting probe cycles ..... 548
Recording measured values from the touch-probe cycles ..... 549
Writing the measured values from touch probe cycles in datum tables ..... 550
Writing the measured values from touch probe cycles in the preset table ..... 551
Storing measured values in the pallet preset table ..... 552
14.7 Calibrating a 3-D Touch Probe ..... 553
Calibrating the effective length ..... 553
Calibrating the effective radius and compensating center misalignment ..... 554
Displaying calibration values ..... 555
Managing more than one block of calibrating data ..... 555
14.8 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 556
Basic rotation using 2 points: ..... 558
Determining basic rotation using 2 holes/studs: ..... 560