HEIDENHAIN CNC Pilot 4290 Instructions for engraving cycles - Manual (Page 10)

8 HEIDENHAIN DataPilot 4290 V7
1.4 Example: Engraving the Lateral Surface
Character string “Steuerungen”
The character string “Steuerungen” (“Controls”) is
engraved from –CY to +CY.
Programming the character string:
8 Position the tool to Z=–150 and C=–45°
8 Parameters for subprogram call:
„ Letter height: LA=12 mm
„ Angle: LB=0° (from –CY to +CY)
„ Milling depth to diameter 120 (LC=120)
„ Retraction depth to diameter 126 (LC=126)
„ Engraving on the lateral surface (LE=1)
„ Linear character string (LF=0)
„ Diameter (for G120): LH=120
„ Separation factor: 1.3 * default separation (I=1.3)
Example: Program and block structure
. . .
N17 G0 X126
N18 G0 Z-150
N19 G110 C-45
N20 L"S" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N21 L"KT" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N22 L"KE" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N23 L"KU" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N24 L"KE" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N25 L"KR" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N26 L"KU" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N27 L"KN" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N28 L"KG" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N29 L"KE" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N30 L"KN" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N31 L"BLANK" V1 LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N.. . . .