Polaris 2015 Polaris M1400 - Manual (Page 54)

52
MAINTENANCE
Periodic Maintenance Chart
Perform all services at whichever maintenance interval is reached first. Check and lubricate
all components at the intervals outlined in the Periodic Maintenance Chart, or more often
under severe use, such as wet or dusty conditions. Items not listed in the chart should be
lubricated at the general lubrication interval.
Ź Perform these procedures more often for vehicles subjected to severe use.
E Emission-Related Service.
D Have an authorized GEM dealer perform these services.
Item Maintenance Interval
(whichever comes first)
Remarks
Hours Calendar Miles (Km)
Steering -
Pre-Ride
-
Inspect and make adjustments as
needed. See Pre-Ride Checklist on
page 30.
Front suspension - -
Rear suspension - -
Tires - -
Brake fluid level - -
Brake pedal travel
Brake system
- -
Wheels/fasteners - -
Frame fasteners - -
Batteries - -
Engine oil level -
Headlamp/tail lamp - Daily - Check operation; apply dielectric
grease if replacing
Ź
E
Air filter, pre-filter - Daily - Inspect; clean often; replace as needed
Coolant - Daily - Check level
Ź
E
Air filter - Weekly - Inspect; replace as needed
Fuel System 25 H Monthly - Inspect; cycle key to pressurize fuel
pump; check lines and fittings for leaks
and abrasion
Ź Front Gearcase oil (if equipped) 25 H 1 M - Perform a break-in oil level check
Ź Middle Gearcase oil (if equipped) 25 H 1 M - Perform a break-in oil level check
Ź Rear gearcase oil (if equipped) 25 H 1 M - Perform a break-in oil level check
Ź Transmission oil
25 H 1 M - Perform a break-in oil level check
Ź Engine oil change (break-in) 25 H 1 M - Perform a break-in oil change at one
month
Ź
D
Brake pad wear 50 H Monthly - Inspect periodically
Ź General lubrication 50 H 3 M - Lubricate all fittings, pivots, cables, etc.
D Steering 50 H 6 M - Lubricate
Ź Front suspension 50 H 6 M - Lubricate
Ź Rear suspension 50 H 6 M - Lubricate
D
E Throttle cable/Release switch 50 H 6 M 500 (800) Inspect; adjust; lubricate; replace if
necessary
E Throttle body air intake ducts/
flange
50 H 6 M 500 (800) Inspect duct for proper sealing/air leaks
Drive belt 50 H 6 M 500 (800) Inspect; adjust; replace as needed