Polaris 2014 Ranger EV - Manual (Page 33)

31
FEATURES AND CONTROLS
Brake Pedal
Push the brake pedal toward the floor to slow or stop the vehicle. Apply the brakes before
turning the key on.
Accelerator Pedal
The accelerator pedal will function only when the key is
ON and the direction selector switch is set to either
forward or reverse. To begin moving or to increase
vehicle speed, gradually push the accelerator pedal
toward the floor. Holding the accelerator pedal down
continuously will accelerate the vehicle to the maximum
speed.
To slow the vehicle, release the accelerator pedal.
Electric motor braking provides braking when the pedal
is released. For additional speed control or to stop the
vehicle, apply the service brakes.
Roll-Over Protection System (ROPS)
The Rollover Protective Structure (ROPS) on this
vehicle meets OSHA 1928.53 rollover
performance requirements. Always have your
authorized POLARIS dealer thoroughly inspect
the ROPS if it ever becomes damaged in any way.
No device can assure occupant protection in the
event of a rollover. Always follow all safe
operating practices outlined in this manual to
avoid vehicle rollover.
WARNING! Vehicle rollover could cause severe injury
or death. Always avoid operating in a manner that could
result in vehicle rollover.
Seat Removal
Pull up on the front of the seat to disengage the front latches. Slide the seat forward and lift it
away from the seat base.
To reinstall the seat, align the rear seat tabs with the slots on the rear of the seat base. Slide
the seat fully rearward, then push down firmly along the front edge of the seat to secure the
latches.
Accelerator
Pedal
Brake
Pedal
ROPS Cab
Frame