Extron electronic Cable Cubby 800 EU - Manual (Page 16)

Cable Cubby ® Products • Maintenance and Modifi cations
Maintenance and Modifi cations, cont’d
3-4 Cable Cubby ® Products • Maintenance and Modifi cations 3-5
4 . Cable Cubby 200 — Remove the screws at the four corners
that secure the cubby to the table (fi gure 3-2).
Figure 3-2 — Removing the Cable Cubby 200
5 . Lift the enclosure from the table.
W The fl anged edges of the top of the surface enclosure
are sharp. Exercise caution when the cubby is not
installed in a table to prevent personal injury.
C The fl anged edges of the top of the cubby are
bevelled to an ultra-fi ne thickness of less than
0.04 (4/100)" (approximately 1 mm). These
edges are soft and can be easily nicked or bent.
Exercise caution when handling and mounting the
enclosure. Mishandling can damage the appearance
of the enclosure.
6 . Remove the AAP shelf assembly(s) or power module by
removing the four Phillips head screws on the front and
rear of the Cable Cubby and gently pushing the assembly
out through the bottom of the cubby.
7 Perform the desired maintenance procedure.
8 . Carefully lower the Cable Cubby into the hole in the table.
9 . Cable Cubby 300, 600, and 800 — From the underside of
the table, reinstall the screw clamps on the enclosure at a
height at which the clamp will reach the underside of the
tabletop.
C Do not overtighten the Phillips head screws on
the screw clamps. Overtightening can bend the
horizontal fl ange of the screw clamp
10 . Cable Cubby 300, 600, and 800 — Snugly tighten the
Phillips head screws on the screw clamps to secure the
enclosure to the surface.
11 . Cable Cubby 300, 600, and 800 — Tighten the locking
thumbscrews on the screw clamps to lock the clamp in
position.
12 . Cable Cubby 200 — Fasten the Cable Cubby 200 to the
table with the four 6-32 x 1/2" screws removed in step 4
(fi gure 3-2).
Replacing Cables or an AAP
Before you change the cables inside the cubby or replace one or
more AAPs on Cable Cubby 300, 600, and 800 models, you must
remove the AAP shelf assembly from the Cable Cubby. Use the
following guidelines as applicable:
1 Cable Cubby 300, 600, and 800 — If the Phillips head
screws on the front and rear of the cubby are blocked by
the table, remove the cubby from the table. See Removing
and Replacing the Cable Cubby, steps 1 through 4, earlier in
this chapter.
2 Cable Cubby 300, 600, and 800 — Remove the AAP shelf
assembly(s) by removing the four Phillips head screws on
the front and rear of the Cable Cubby and gently pushing
the assembly out through the bottom of the cubby.
3 Change the cables and/or AAPs the same way you
installed them. See Installing the Cables and AAPs in
chapter 2, Installation.
4 Cable Cubby 300, 600, and 800 — If you removed
the cubby from the table, reinstall the surface mount
enclosure. See Removing and Replacing the Cubby, steps 8
through 11, earlier in this chapter.