Grass Valley Terrapin FTR-D6 - Manual (Page 16)

12
Components and Operator Modes
The Fiber I/O and Power panel
The Fiber I/O and Power panel
The Terrapin FTR-D6 Fiber I/O and Power panel has four connectors. Each function
corresponds to the label indicated on the top panel of the unit.
Fig. 2-7: Fiber I/O and Power Panel
1 The Power Connector is a 4-pin XLR type connector that takes a nominal 12V power
supply. The supplied power supply is the ADAP-AC-04-X, with X being the specific
geographic region covered (see
Ordering Information on page 5).
The unit can also be powered by the optional External Battery option, which allows the
use of an Anton-Bauer or "V-Mount" type battery (see
Installing and Using the External
Battery Operation on page 22).
2 The Terrapin FTR-D6 is equipped with an RJ45 data connector, which allows for future
firmware changes or upgrades. Currently, this connector has only a maintenance
function.
3 Fiber Optic ST Connector for Single Mode Fiber signal input.
4 Fiber Optic ST Connector for Single Mode Fiber signal output for transmitting the
connected BNC input, or for re-transmitting the Fiber Optic signal received on the Fiber
signal input (connector #3).
For a list of all supported signal types, see Supported Signal Types on page 17.