Mode select switch operation, The fiber and power labels – Grass Valley Terrapin FTR-D6 User Manual
Page 13
9
Terrapin FTR-D6
User Guide
Mode Select Switch Operation
The mode select switch allows the selection of one of the four operating modes available
with the Terrapin FTR-D6.
To select a mode
1 Hold the Mode Select switch down for four seconds.
Fig. 2-2: Mode Select switch
2 Observe the flashing LED indicators to determine the current operating mode and if
you want to change the mode, push the switch once. The Terrapin FTR-D6 will advance
to the next mode.
Keep pushing the switch until you reach the desired mode. As you cycle through the
modes the LEDs will change to indicate the active signal path.
3 When the desired mode is reached, release the switch and after four seconds, the
Terrapin FTR-D6 is programmed with the selected mode.
The Fiber and Power Labels
The Fiber and Power Labels serve two functions. These are the labels for the connectors
directly below the labels on the end panel of the Terrapin FTR-D6. The In and Out labels also
serve as indicators/end points for the LED signal path indicators.
• The LED function is described in
• The physical connectors are described in
Fig. 2-3: Fiber and Power Labels
Note: If you pass by the desired mode, you must cycle through the
various modes until you get to the one you want. The Terrapin FTR-D6
will retain the last set mode when powered off.
For more information on the four modes please see