Shed-bs configuration for camera types, Shed-c and panasonic 3800 camera, Figure 2-2 – Grass Valley SHED Jan 16 2015 User Manual
Page 8
4
Installation and Configuration
Fig. 2-2: Active SHED-HDX System
In each case, a SHED-BS returns an electrical signal to the base station that facilitates the
operation of the camera even though there is no physical copper connection. The SHED-BS
requires no external power supply.
SHED-BS Configuration for Camera Types
The SHED-BS supports multiple camera types, and each has different interface
requirements at the CCU end. The SHED-BS must be manually configured for the type of
camera in the system, using four DIP switches on the side of the case. A label is mounted on
the case to show the switch positions for the supported cameras.
SHED-C and PANASONIC 3800 Camera
The Panasonic 3800 camera is a special case - the SHED-C is used to feed power to the
camera. A jack on the SHED-C case accepts 12 VDC, and the 10 VDC required for the camera
is fed down the hybrid fiber cable to the camera.
Camera
Sw 1
Sw 2
Sw 3
Sw 4
Sony
ON
ON
ON
OFF
Hitachi HD5000
OFF
ON
ON
OFF
Ikegami
ON
OFF
ON
OFF
Panasonic 3500
OFF
OFF
ON
OFF
Panasonic 931B
ON
ON
OFF
OFF
Panasonic 3800
OFF
ON
OFF
OFF