Grass Valley Profile Serial Digital - Manual (Page 27)

Installing the Serial Digital I/O Board
Serial Digital I/O Upgrade Installation 19
Installing the Serial Digital I/O Board
Refer to the board I/O requirements and restrictions in Table 1 and install the
board as follows:
1. If necessary, remove the slot cover where you want to install the board—J15,
in this example.
2. Align the board with the connectors on the motherboard. Make sure the
extractor on the front end of the board is in the up position, then press down
on the board firmly until the board is seated. As you push the board into the
connectors, you will feel the board engage first one, then a second set of
contacts in the connector. The board is properly seated when the top of the
rear mounting bracket is resting on the rear chassis wall shelf.
3. Use the Torx tool with the T15 tip to install the mounting screws in the top
of the bracket inside the chassis ( Ê in Figure 4) and through the rear panel
at the bottom of the bracket ( Ë in Figure 4).