Grass Valley Profile Serial Digital - Manual (Page 11)

Installation Procedures
Serial Digital I/O Upgrade Installation 3
Installation Procedures
The procedures that follow take you step-by-step through the installation of the
serial digital I/O board. You can install the board with the Profile chassis fully
extended on the rack slides if the equipment rack is adequately anchored to prevent
tipping, and if there is sufficient slack in the cables connected to the rear panel to
allow the chassis to fully extend on the slides.
If it is necessary for you to remove the Profile unit from the equipment rack to
perform this installation, refer to the Profile system’s installation manual for
instructions.
WARNING: Unless the equipment rack is adequately anchored, the rack
could tip when the chassis is extended on the rack slides. To avoid possible
injury, make sure the rack is firmly secured before extending the chassis on
the rack slides.
!