Grass Valley NV96xxV Windows v.1.7 - Manual (Page 16)

12
Virtual Control Panels
Virtual Control Panels
Disconnect
Use this command to disconnect a virtual panel from the router control system.
About
Use this command to obtain the current software revision data:
It is especially important to know this information when you are placing calls to technical
support.
Exit
Use this command to close the virtual panel application. It is automatically disconnected. The
router control system requires a few seconds to detect that the panel was disconnected.
Notes
Diagnostic Launch
(Diagnostic launch is available only under Windows.)
By holding the CTRL key down when you launch a virtual panel, you can place the panel in a
diagnostic mode. This mode displays a “DOS box” (in addition to the virtual panel) that you can
use to monitor the exchange between the virtual panel software and the system controller.
This is an example of such an exchange: