Grass Valley KXI-DVI-Bridge - Manual (Page 11)

USER’S MANUAL
2.3 Connections
All inputs and outputs are located on the rear panel of the KXI-DVI-Bridge. Signals and connector types are
listed below. The rear panel labels indicate the appropriate connection point for each signal.
Mounting screw
connection point RS-232/GPI port
(used for dongle)
USB port (used for
firmware upgrade)
Figure 2.2 Rear panel and connectors of KXI-DVI-Bridge
Signal connections:
2 DVI inputs (DVI-D IN A and DVI-D IN B) (DVI connectors)
2 DVI outputs (DVI-D OUT A and DVI-D OUT B) (DVI connectors)
4 HD-SDI outputs (Out A x 2 and Out B x 2) (BNC connectors)
For optimum performance, high-quality DVI cables should be used. One recommended cable model is
D-766 from Cable4PC (
www.cable4pc.com )
Dongle:
A dongle with an RJ45 connector ships with new systems, and is included with upgrade packages.
Insert this dongle in the RS-232/GPI port on the rear panel of the KXI-DVI-Bridge to enable Mode B
functionality (refer to page 2).
KXI-DVI-Bridge | 7