Initial configuration – Extreme Networks Sentriant AG200 User Manual
Page 23
Sentriant AG200 Hardware Installation Guide
23
Initial Configuration
NOTE
If endpoints are already attached to a switch when you install Sentriant AG, you must log in to each switch and
send the NAC revalidate command before the endpoint can be tested and routed properly.
To configure the Sentriant AG appliance:
1
Log in to a different computer with browser software installed. The following browsers are
supported for this release:
●
Windows: IE 6.0 or later, Mozilla Firefox v1.5 or later, Mozilla v1.7
●
Linux: Mozilla Firefox v1.5 or later, Mozilla v1.7
●
Mac OS X: Mozilla Firefox v1.5 or later
2
Using https://, point your browser to the IP address or host name of the Sentriant AG appliance (for
example, https://10.0.64.25).
3
You might be prompted with a security alert because Sentriant AG uses a secure communication
connection (SSL) (
Figure 5
). Click Yes. The Accept license agreement window opens (
).
Figure 5: Security Alert Window
Figure 6: Accept License Agreement Window