Grass Valley KMV-3901 Jul 30 2012 - Manual (Page 13)

GUIDE TO INSTALLATION AND OPERATION
KMV-3901/3911 | 9
3.3.3 Saving a Restore Point to the Controller’s Non-Volatile Memory
The Densité CPU-ETH2 controller can be configured to automatically apply parameters from a previously
saved restore point, when you replace a card with another card of the same type. In the case of a KMV-
3901/3911 card the restore point includes the multi-viewer’s system name and networking parameters.
To save a restore point to the controller’s non-volatile memory, proceed as follows:
1. On the Densité frame’s local control panel, press the CONTROLLER button.
2. Press the [–] button repeatedly until RESTORE POINTS appears on the display, and then press the
SELECT button.
3. Press the [–] button repeatedly until SAVE A CARD appears on the display, and then press the
SELECT button.
4. Press the [–] button repeatedly until CARD # N—where N matches the slot number for the Kaleido-
Modular card whose configuration you wish to save—appears on the display, and then press the
SELECT button.
3.4 Remote Control Using iControl
The operation of the KMV-3901/3911 may be controlled by using Miranda’s iControl version 3.60 or later.
• This manual describes the control panels associated with the KMV-3901/3911 and their use.
• Please consult the iControl User’s Guide for information about setting up and operating iControl.
In iControl Navigator or iControl Web, double-click a KMV-3901/3911 icon to open the associated control
panel.