Grass Valley Kaleido-IP with Kaleido-X Cascade Manual User Manual

Page 4

Text mode
Original mode

Physical Installation

To interconnect a Kaleido-IP and a Kaleido-X into a cascade

1 Connect one of the Kaleido-IP’s DisplayPort outputs to a DVI input on the Kaleido-X

output card that will be connected to the monitor wall.

2 In the case of a cascade room with two output heads, connect the second DisplayPort

output on the Kaleido-IP to the second DVI input on the Kaleido-X.

3 Connect the appropriate outputs on the Kaleido-X to one or two monitor wall displays,

depending on your specific purposes.

Note:

Although nothing prevents you from connecting any DisplayPort

output to any DVI input, the recommended practice is to choose the most
logical signal path, by connecting DP1 to DVI-D IN 1, and DP2 to the same
output card’s DVI-D IN 2. Configuring your cascade system in XEdit will then
be straightforward.