Grass Valley Kaleido-IP with Kaleido-X Cascade Manual - Manual (Page 11)

9
Kaleido-IP/Kaleido-X cascade
Step-by-Step Configuration
10 Click Yes to proceed.
Your multiviewer will shut down, and then start again. This may take a while.
Once the multiviewer has restarted, the system notifies you.
11 Click OK.
The XAdmin Status and Options page appears.
12 Verify that the expected version number appears in the page title (check the tab label,
or the browser’s title bar).
At this point the Kaleido-IP upgrade is complete, and you can now proceed with
upgrading the Kaleido-X.
13 Copy the Kaleido-X upgrade package files to a USB key (see “Preparing a USB Key” in
the Release Notes).
14 Insert the USB key into any of the USB ports on the Kaleido-X.
After a while, a message appears at the bottom left corner of the monitor wall, report-
ing that the Upgrade Manager is verifying software, firmware, and safe mode versions.
Once the verification process is complete, you will be advised what upgrade action, if
any, needs to be performed. Then, after 30 seconds, the upgrade process begins auto-
matically, starting with the software upgrade.
IMPORTANT
In a Kaleido-X multiviewer, all cards are updated in parallel, during which
time their status LEDs will be flashing red. Do not interrupt this process. Do
not insert or remove cards while an upgrade is in progress.