Epson 1080 - Manual (Page 44)

44
Making Detailed Adjustments
■ Startup Screen
Turn this setting off if you want to prevent the startup screen from appearing while the
projector is warming up.
■ Display Background
Changes the screen that’s used when the projector is not receiving a signal or when you
press the
Blank button to temporarily stop projection.
Other Setup Options
■ Projection
You can select different options for projecting the image: Front , Front/Ceiling , Rear ,
Rear/Ceiling .
■ Direct Power On
Sets projection to start when the main power switch is turned on, without pressing the
On button on the remote control or the P Power button on the projector.
Note: When direct power on is enabled, power surges that occur after a power outage can
cause the projector to turn on.
■ Video Signal
Leave this setting on Auto so the projector can automatically interpret the format, such as
NTSC or PAL (for standard TV formats).
■ Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
Auto to let the projector automatically interpret the signal;
or select YCbCr or YPbPr to manually select your video equipment’s signal.
Settings Æ Display Æ Startup Screen
Settings Æ Display Æ Display Background
Settings Æ Projection
Settings Æ Direct Power On
Settings Æ Input SignalÆ Video Signal
Settings Æ Input SignalÆ Component