Grass Valley DAP-1781 - Manual (Page 16)

GUIDE TO INSTALLATION AND OPERATION
16 | DAP-1781
3.2 Menu for local control
The DAP-1781 has operating parameters which may be adjusted locally at the controller card interface. After
pressing the SELECT button on the DAP-1781 module, use the keys on the local control panel (described in
the Controller card manual) to step through the displayed menu and adjust the parameters. The menus are
shown below.
STATUS HW ERR: parameter1 | [CARD SYS: parameter2, REF:
parameter3, RATE: parameter4, [REAR: parameter5 | REAR
PANEL ERROR]]
parameter1 = OK | VALIDITY | CRCC | PARITY | BIPHASE | NO
LOCK
parameter2 = UNKNOWN | 192kHz | 96kHz | 88.2kHz | 48kHz |
44.1kHz | 32kHz
GENERAL
AES1 parameter1, AES1 FRQ parameter2, ..., AES4 parameter1,
AES4 FRQ parameter2 AES IN
parameter3 = A-BUS (V) | A-BUS (A) | FRAME (10) | FRAME
(20) | AES1 | FREE-RUN (depends on rear, cards present on A-
BUS and reference distribution cards in frame)
ALL OK | [CH1 parameter , …, CH16 parameter]
CHANNEL STATUS AES 1L
AES 1R
AES 4L
AES 4R
CHANNEL USE, PCM SAMPLES, EMPHASIS, FREQ MODE,
SAMPLING FREQ, CHANNEL MODE, USER-BIT, AUX.BITS,
WORD LENGTH, REFERENCE, SOURCE ID, DESTINATION ID.
Each item will be placed on the first line and it’s corresponding
status on the second line.
AUDIO TYPE CH1 parameter, ..., CH16 parameter
parameter = PCM | NON-PCM | DOLBY E | AC-3
parameter5 = UNSUPPORTED | 110-DRP | 75-DRP | ENC-75-
SRP | DEC-75-SRP | ENC-110-SRP | DEC-110-SRP
...
DOLBY DECODER
FORMAT
METADATA * **
PROGRAM 1*
PROGRAM 8*
...
W.X.Y.Z
[DOLBY D 32 | DOLBY D 16 CH1 | DOLBY D 16 CH2 | DOLBY D 16 CH1&2 |
DOLBY E 24 | DOLBY E 20 | DOLBY E 16 | PCM], [5.1+2 | 5.1+2x1 | 4+4 |
4+2x2 | 4+2+2x1 | 4+4x1 | 4x2 | 3x2+2x1 | 2x2+4x1 | 2+6x1 | 8x1 | 5.1 | 4+2 |
4+2x1 | 3x2 | 2x2+2x1 | 2+4x1 | 6x1 | 4 | 2x2 | 2+2x1 | 4x1 | 7.1 | 7.1 Screen]*,
[[23.98 | 24 | 25 | 29.97 | 30] fps]*, [1+1 | 1/0 | 2/0 | 3/0 | 3/0L | 2/1 | 2/1L | 3/1 | 3/
1L | 2/2 | 2/2L | 3/2 | 3/2L]**, [[32 | 40 | 48 | 56 | 64 | 80 | 96 | 112 | 128 | 160 |
192 | 224 | 256 | 320 | 384 | 448 | 512 | 576 | 640] kbps]**
DIALOGUE LEVEL, CHANNEL MODE, LFE CHANNEL, DATA RATE**,
BITSTREAM MODE, LINE MODE PRO, RF MODE PRO, RF OVER
PROTECT*, CENTER DWNMX, SRND DWNMX, DOLBY SRND, AUDIO PROD
INFO, MIXING LEVEL, ROOM TYPE, COPYRIGHT, ORIG BITSTREAM,
EXTEND BSI 1, PREF DWNMX, Lt/Rt C DWNMX, Lt/Rt S DWNMIX, Lo/Ro C
DWNMX, Lo/Ro S DWNMX, DOLBY SRND EX, HEADPHONE MODE, A/D
CONV TYPE, DC FILTER*, LOWPASS FILTER*, LFE FILTER*, SRND 3dB
ATTN*, SRND PH SHIFT*
* Dolby E only
** Dolby Digital only
upMAX
W.X.Y.Z
INPUT PROCESSING
parameter4 = 23.98 fps | 24 fps | 25 fps | 29.97 fps | 30 fps
parameter1 = FPGA | DIR | DATAFLASH | DOLBY | DUP-701
COMMON* PROGRAM CONFIG, FRAME RATE
Each item will be placed on the first line and it’s corresponding status on the
second line.
ERROR STATUS
FIRMWARE VERSION
Each item will be placed on the first line and it’s corresponding status on the
second line.
NO ERRORS | DOLBY D FRAME | DOLBY D CRC | DOLBY D DECODE |
DOLBY E CRC | DOLBY E DECODE | DOLBY E MD | DOLBY E AC-3 MD |
UNSUP FRAME RATE | UNSUP PROG CONF
parameter = OK | [SILENCE, OVERLOAD, MUTE, TONE]
parameter2 = OK | ERROR
CURR PROCESSING
FIRMWARE VERSION
OFF, PASS-THROUGH, UPMIX, AUTOMAX