Grass Valley 1-CCD CameraMan Rev.D1 - Manual (Page 13)

Page 10
CameraMan® 1-CCD Camera Control Keypad Operations Manual
Operating Your Camera Control Keypad
To move quickly from view to view using the Camera Control Keypad, use the location preset function on the keypad. With location
presets, you can store and recall up to 99 pre-determined views by following these steps.
Working With Location Presets
What are Location Presets?
Location Presets are stored locations that can be recalled using the Camera Control
Keypad. Each Location Preset stores the following camera control settings:
• PAN/TILT position
• ZOOM perspective
• IMAGE setting
To Set or Change a Location Preset
1. Select the camera you want to program using the CAMERA SELECT buttons
(if you are using only one camera, press CAMERA SELECT 1).
2. Use PAN/TILT arrows to move the camera to the desired location.
3. If desired, use ZOOM In/Out to set the needed Zoom perspective.
4. If desired, use the manual IMAGE buttons to set the needed brightness.
5. Enter a Location Preset number (1–99).
6. Press and hold ENTER until you hear two beeps.
The two beeps indicate that the Location Preset has been stored.
To Recall a Location Preset
1. Select the camera (if only using one camera,
press CAMERA SELECT 1).
2. Enter the Location Preset number (1–99).
3. Press and release ENTER.
The CameraMan camera will move to the memorized location and recall the information
stored for that Location Preset.
Each CameraMan camera can store and recall up to 99 Location Presets.
Step 1
Step 2
Step 3 Step 4
Step 5
Step 6