Grass Valley 1-CCD CameraMan Rev.D1 - Manual (Page 10)

Page 7
UP DOWN
SWITCH BANK -A-
1 2 3 4 5 6 7 8
UP
DOWN
SWITCH BANK -A- SWITCH BANK -B-
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
S-VIDEO
COMPOSITE
BASE UNIT ADDRESS TALLY LIGHT INTERFACE
UP
DOWN
SWITCH BANK -A- SWITCH BANK -B-
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
S-VIDEO
COMPOSITE
BASE UNIT ADDRESS TALLY LIGHT INTERFACE
T-Connector
Camera 2
Camera 3
Camera 1
SWITCH BANK -B-
1 2 3 4 5 6 7 8
S-VIDEO
COMPOSITE BASE UNIT ADDRESS TALLY LIGHT INTERFACE
BASE UNIT
ADDRESS
BASE UNIT
ADDRESS
BASE UNIT
ADDRESS
BASE UNIT
ADDRESS
0 1 2 3 45 67 8 9 A BC DE F
Back of Camera Control Keypad
Configure Your Camera Control Keypad
Multiple Camera Applications
Multiple Camera Control (hard-wired mode)
In this mode, the keypad communicates with camera one (1) using the hard-wired connection.
Any commands sent to cameras two or three will be received by camera one and sent to the
proper camera using RS-485 communications.
1. Make sure your cameras are daisy-chained together.
See your 1-CCD CameraMan Installation and Operations Manual for more
information on daisy-chaining your cameras together.
2.. Connect the Keypad to the PVI COM port on camera one (1) using the CameraMan
Keypad Cable (hard-wired mode only).
3. Set the KEYPAD ADDRESS on your Camera Control Keypad to match the BASE UNIT
ADDRESS on the first camera.
See page 3 for more information on setting the KEYPAD ADDRESS.
4. Set the BASE UNIT ADDRESS on the second and third cameras to successively
follow the address that you used for the first camera.
Example:
Camera Base Unit Address Keypad Address
1 0 0
2 1
3 2
5. Disable or enable the RF Command configuration switch on all cameras. THis setting
will not affect functionality.
See your 1-CCD CameraMan Installation and Operations Manual for
more information on setting the configuration switches on your CameraMan
camera(s).