Grass Valley ADVC-HDM1 - Manual (Page 9)

– 6 –
a Encode/Decode Switch
Press and hold for more than 1 second to
change as follows: [Encode Mode]
→
[Decode Mode] or [Decode Mode] →
[Encode Mode].
The default setting is [Decode Mode].
b Time Code Input Switch
Press and hold for more than 1 second to
change as follows: [DVITC Input]
→ [LTC
Input] or [LTC Input] → [DVITC Input]
(enabled only during [Encode Mode]).
The default setting is [DVITC Input].
c Encode Selection LED
On:
Indicates that the encode mode is
selected.
Encode selection LED and FORMAT indi-
cator LED flash at the same time:
Indicates that the ADVC-HDM1 is waiting
for a signal input from the HD-SDI.
d Decode Selection LED
On:
Indicates that the decode mode is
selected.
Decode selection LED and FORMAT
indicator LED flash at the same time:
Indicates that the ADVC-HDM1 is wait-
ing for a stream input from the
IEEE1394a port.
NOTE
When the [Encode Selection LED] and
[Decode Selection LED] flash at the same
time, it indicates that the mode is in transition.
e VITC Enabled LED
Comes on when DVITC is enabled during
encode mode.
f LTC Enabled LED
Comes on when LTC is enabled during
encode mode.
NOTE
The [VITC Enabled LED] and [LTC Enabled
LED] come on when decode mode is
selected and the stream is HDV. Neither
come on if the stream is not HDV.
1
Part Names and Functions
1-1 ADVC-HDM1 Front Panel
a b
c d e f g h i j k
ADVC_HDM1_EN.book Page 6 Tuesday, December 19, 2006 9:20 AM