Grass Valley ADVC-HDM1 - Manual (Page 24)

– 21 –
„ Serial Interface
RS-232C, 9600 bps, 8-bit, parity none, stop bit = 1 bit
„ Command List
2
List of Commands
2-1 Remote Control Function
PL Start playback if the current mode is not playback (encode)
Format: “PL”
Status report: Completion message (“R”)
RC Start record if the current mode is not record (decode)
Format: “RC”
Status report: Completion message (“R”)
SO If the current mode is playback (encode), stop playback and
start record
Format: “SO”
Status report: Completion message (“R”)
?P Check the current operation mode
Format: “?P”
Status report: “P02”: ADVC-HDM1 starting or mode in transi-
tion
“P04”: Playback (encode)
“P14”: Record (decode)
TC Change the input time code setting for encoding to VITC or
LTC
Format:
“(Integer) TC”
“1TC” VITC
“2TC” LTC
Status report: Completion message (“R”)
E06: Command argument error (integer is
neither 1 nor 2)
When the input time code is changed during decode opera-
tion, the changed setting is enabled from the next encode
operation.
?T Check the input time code setting of the current encoding
Format: “?T”
Status report: “1”: VITC
“2”: LTC
05_Appendix_ADVC_HDM1_EN.fm Page 21 Wednesday, December 20, 2006 12:37 PM