Grass Valley ADVC-HDM1 - Manual (Page 12)

– 9 –
Use the DIP switches on the rear panel of the ADVC-HDM1 to set the operation
mode. The default setting for all the DIP switches is OFF.
* Slide down the lever to set the DIP switch to ON.
1-3 DIP Switches
No. Name Function
1
IEEE1394a data rate Selects the IEEE1394a data rate
OFF: S400 ON: S200
2
Start mode Selects the start mode
OFF: Normal operation ON: Firmware update mode
3
Serial port switch Selects the serial port
OFF: RS-422A ON: RS-232C
4 Reserved Not used
5
MP@HL
1920 encode mode Operates with MPEG2-TS 1920 × 1080/59.94i during encod-
ing
* This setting is ignored if the input video is not 1920 × 1080/59.94i
6, 7, 8 Encode bit rate Selects the video bit rate for encoding
* The bit rate changes are enabled from the next encoding
SW6 SW7 SW8 Operation
OFF OFF OFF 18.3 Mbps (HDV 720p) or 25 Mbps
(HDV 1080i)
* Outputs a stream compatible with the
HDV standard
* Encodes with MPEG2-TS and
25 Mbps when SW5 is ON and the
input video is 1920
× 1080/59.94i
OFF OFF ON 40 Mbps
* MPEG2-TS
OFF ON OFF 30 Mbps
* MPEG2-TS
OFF ON ON 20 Mbps
* MPEG2-TS
ON OFF OFF 18 Mbps
* MPEG2-TS
ON OFF ON 16 Mbps
* MPEG2-TS
ON ON OFF 14 Mbps
* MPEG2-TS
ON ON ON 11 Mbps
* MPEG2-TS
* The settings can be changed with the
AV/C Canopus Vendor dependent
command or via the RS-232C
ADVC_HDM1_EN.book Page 9 Tuesday, December 19, 2006 9:20 AM