2 advc-hdm1 rear panel – Grass Valley ADVC-HDM1 User Manual

Page 11

– 8 –

a LTC Output Terminal

This is the time code output (BNC) termi-
nal.
The HDV time code is output during HDV
decoding.

b LTC Input Terminal

This is the time code input (BNC) termi-
nal. A time code can be input for writing
to HDV during HDV encoding.

c ACTIVE THROUGH Terminal

This is the ACTIVE THROUGH terminal.
ACTIVE THROUGH is performed for the
input signal.

d SDI Input Terminal

This is the HD-SDI input terminal.

e SDI Output Terminal

This is the HD-SDI output terminal.

f Power Switch

This is the power switch. Use to turn the
ADVC-HDM1 ON or OFF.

g IEEE1394a 6-pin Terminal

This is an IEEE1394a 6-pin terminal. It
does not supply bus power.

h DIP Switches

Use to set the operation mode (refer to
the next page).

i RS-232C Terminal

The remote control terminal.

NOTE

The default setting for the encode bit rate via
RS-232C terminal remote control is 11 Mbps.

j RS-422 (CONTROLLER) Terminal

This is the RS-422 CONTROLLER termi-
nal. Connect as appropriate to the device
that you are using.

k RS-422 (DEVICE) Terminal

This is the RS-422 DEVICE terminal.
Connect as appropriate to the device that
you are using.

NOTE

Only use one of the following terminals at any
one time: RS-232C terminal, RS-422 (CON-
TROLLER) terminal and RS-422 (DEVICE).

l Power Terminal

Use to connect the supplied AC adapter.
Never connect to anything other than the
supplied AC adapter.

1-2

ADVC-HDM1 Rear Panel

ADVC_HDM1_EN.book Page 8 Tuesday, December 19, 2006 9:20 AM