Grass Valley 2041EDA - Manual (Page 9)

2041EDA Instruction Manual 9
Installation
Cabling
Cabling to the 2041EDA module is done on the BNCs on the rear of the
module. Refer to
Figure 2 for a detailed illustration of the rear connections
referenced below.
Inputs
The 2041EDA will accept any of the video standards listed in the Input
specifications in
Table 3 on page 14 . Connect a video input to BNC J10.
Outputs
The 2041EDA outputs conform to the video standards listed in the Output
specifications in
Table 3 on page 14 .
Connect video destinations to any of the eight outputs at connectors J2 – J9.
Terminate any unused outputs.
Note BNC J1 is not used on this module. On earlier versions of the 2041EDA
labeled with part number 671-5248-00, BNC J1 provided an output.
Figure 2. 2041EDA Input/Output Connectors
8032_02r1 J10 SIG J9 J8 J7 J6 J5 J4 J3 J2 J1
In 2041EDA
Outputs Signal Present
LED
Video
Input Not
Used