H3C Technologies H3C Intelligent Management Center - Manual (Page 65)

7-4
time, you need to set the endmatch attribute to 1, meaning to match
only the last part of the OID (separated into several parts by dots).
On the SNMP configuration page as shown in Figure 7-5 , assume
you want to associate the ifindex node in the ifTable with the
entAliasMappingIdentifier node in the entAliasMappingTable.
Because the entAliasMappingIdentifier node uses the complete
OID for ifIndex, while the ifTable uses only the last part of the OID for
ifindex, you need to set the endmatch attribute to 1 during the
association.
Figure 7-5 Set the endmatch attribute
What Entities Does the Dependent Project 0_devicepanel
Comprise?
The system provides a common project 0_devicepanel that defines
some common entities, SNMP tables, and statuses.
By default, the common project provides power module, fan, and port
entities. An electrical port and an optical port, respectively with vendor