H3C Technologies H3C Intelligent Management Center - Manual (Page 64)

7-3
new project are probably different from those of the project in the iMC.
Therefore, when you upload the new project to the iMC, the new
project and the existing project conflict. To address this issue, the iMC
provides the project comparing function. That is, the iMC compares
the newly uploaded project and the project that has the same
enterprise ID in the iMC.
As shown in Figure 7-4 , compared with the existing project, S7510E
is added in the newly uploaded project and the definition of
hh3cLswPortTable is also different. You can select the configuration
you want to update as needed.
Figure 7-4 Compare the new project with the existing project
What Is the Endmatch Attribute in VPD Used for?
The endmatch attribute is typically used to process MIB object
identifiers (OIDs). In most cases, MIB values on the device are
complete MIB OIDs. For example, the complete MIB OID of an H3C
interface module LSQ1CGP24TSC0 is 1.3.6.1.4.1.25506.3.1.9.4.570.
However, the MIB may save only 570 as the card’s OID because the
nodes before 570 are common to all H3C interface modules. At this