H3C Technologies H3C SecBlade FW Cards - Manual (Page 12)

1
Layer 2 forwarding configuration commands
General Layer 2 forwarding configuration
commands
display bridge forwarding statistics
Syntax
display bridge forwarding statistics [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type: Specifies the interface type.
interface-number: Specifies the interface number.
Description
Use the display bridge forwarding statistics command to display Layer 2 forwarding statistics.
If no parameter is specified, Layer 2 forwarding statistics information about all interfaces is displayed.
NOTE:
This command is available only on the SECBLADEII-CMW520-R3166 version.
Examples
# Display the Layer 2 forwarding statistics of all interfaces.
display bridge forwarding statistics
Total received: 888
Filtered:111 STP discarded:0
Broadcast:0 Multicast:0
Unknown Unicast:0 Invalid Tag:0
Total deliver to up: 111
L2 protocol:11 Local MAC address:100
Blackhole dropped:0
Total sent: 666
Filtered:0 STP discarded:0
# Display forwarding statistics of Ten-GigabitEthernet0/0.
display bridge forwarding statistics interface ten-gigabitethernet 0/0