H3C Technologies H3C MSR 50 - Manual (Page 16)

10
To do… Use the command… Remarks
Reset the Linux system of
an OAP/OAPS module
oap reboot slot slotnum
Required
Available in user view
NOTE:
Resetting the OAP/OAPS module may cause data loss and service
interruption. Before resetting the OAP/OAPS module, save the
configurations of the module operating system and shut down the module
operating system to avoid service interruption and data loss.
Configuration examples
Redirecting to an OAP/OAPS module from the router
The OAP/OAPS module is installed in slot 4 on the router.
oap connect slot 4
Connected to OAP
CentOS release 5.4 (Final)
Kernel 2.6.18-164.el5 on an x86_64
localhost login: root
Password:
Last login: Mon Dec4 11:17:00 on ttyS0
You have new mail.
[root@localhost ~]#
Resetting the Linux system of an OAP/OAPS module
The OAP/OAPS module is installed in slot 4 on the router.
oap reboot slot 4
This command will recover the OAP from shutdown or other failed
state.
Warning: This command may lose the data on the hard disk if the
OAP is not shut
down!
Continue? [Y/N]y
OAP is being reboot.