H3C Technologies H3C MSR 50 - Manual (Page 10)

4
LED mark Status Description
DISK
Steady green The disk is in position.
Flashing green
The disk is performing a read/write
operation.
Steady yellow A problem has occurred to the disk.
Off The disk is not in position.
LINK/ACT
Steady yellow A link is present on the port.
Flashing yellow
Data is being transmitted or received
over the link.
100/1000M
Off
(Suppose the LINK/ACT
LED is yellow)
A 10 Mbps link is present.
Steady orange
(Suppose the LINK/ACT
LED is yellow)
A 100 Mbps link is present.
Steady green
(Suppose the LINK/ACT
LED is yellow)
A 1000 Mbps link is present.
Stand By button
Table 3 Stand By button operation description
System status Operation Description
The OAP module is
power off.
Press the Stand By button.
The module is turned on
and the system starts up.
The OAP module is
powered on.
Press and hold the Stand By
button for less than four
seconds. Soft off (the system is shut
down first and then the
module is powered off.)
Press and hold the Stand By
button for more than four
seconds.
Force a shutdown.