H3C Technologies H3C S5560 Series Switches - Manual (Page 5)

5
Keep the removed filler panel secure for future use.
3. Unpack the LSWM2QP2P interface card.
4. Insert the interface card slowly into the slot along the guide rails, as
shown by callout 1 in Figure 3 .
5. Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the interface card is in close contact with the switch.
6. Use the Phillips screwdriver to tighten the captive screw on the
interface card as shown by callout 3 in Figure 3 .
Figure 2 Removing a filler panel
Figure 3 Installing an LSWM2QP2P interface card
1
2
3