H3C Technologies H3C S5800 Series Switches - Manual (Page 14)

9
CAUTION:
•
When you insert the power module into the slot, you can do that
through slight inertia so that the back end of the power module
can have a good touch with the backplane.
• To avoid damaging or bending the terminals of the power
module, if the insertion direction is improper during the
installation, you must pull the power module out, adjust the
direction, and insert it again.
• Save the blank panel and the packaging box and packaging bag
of the power module for future use.
Connecting the power cable
Connecting the AC power cable
WARNING!
•
Make sure that each power cable has a separate circuit breaker.
• Turn off the circuit breaker before connecting the power cable.
Step1 As shown in Figure 5 , plug the female connector end of the AC
power cable into the AC input socket on the switch.