H3C Technologies H3C S6800 Series Switches - Manual (Page 15)

11
2. Press the latch on the interface card to release the ejector lever.
3. As shown by callout 1 in Figure 3 , insert the interface card slowly
into the slot along the guide rails.
4. Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the latch locks the ejector lever in place.
Figure 3 Installing an LSWM124XG2QFC interface card
Removing an interface card
CAUTION:
•
Before you remove an interface card, remove the cable from it to
avoid cable damage.
• After removing an interface card, if no new interface card is to be
installed, install the filler panel as soon as possible to prevent dust
and ensure good ventilation in the device.