Installing and removing a power module, Safety precautions, Tools – H3C Technologies H3C S9800 Series Switches User Manual
Page 10
5
Installing and removing a power
module
Safety precautions
To avoid possible bodily injury and power module and device damage,
follow these safety precautions:
•
When you install and remove a power module, always wear an
ESD wrist strap and make sure it makes good skin contact and is
well grounded.
•
Before you install the power module, make sure the voltage of the
power source is the same as the rated voltage of the power module,
and the output voltage of the power module is the same as the
required voltage.
•
Do not touch any naked cable or terminal of the power module.
•
Do not place the power module in a wet area, and prevent liquid
from flowing into the power module.
•
To avoid power module damage, do not open the power module.
When the internal circuits or components of the power module fail,
contact the maintainer for examining and repairing.
Tools
Prepare an ESD wrist strap and a flat-blade screwdriver yourself.