H3C Technologies H3C S9800 Series Switches - Manual (Page 2)

Manual version: 6PW101-20150202 BOM: 3105A02Y
ii
Figure 2 Locating the rack position for installing slide rails
(1) Positioning tab (2) Lowest square hole within the 2U space on the rack post
3. Install four cage nuts on the square holes on each rack post, as shown in Figure 3 .
Figure 3 Installing a cage nut
4. Perform the following tasks as shown in Figure 4 :
a. Align the installation holes on the front end of the slide rail with the cage nuts on the front rack
post.
b. Compress the slide rail, making sure the positioning tabs at both ends of the slide rail are
inserted into the lowest square holes within the 2U space on the rack posts.
c. Use screws to secure the slide rail to the rack posts.