H3C Technologies H3C S10500 Series Switches - Manual (Page 21)

13
at the lower part of the switch. They are installed in the same way. For more information, see Figure
9 .
• The power cable management bracket installation procedure for the S10508 and S10512 is the
same as S10508-V.
• The power cable management brackets of the S10504 have a slightly different structure, and
installed in a similar procedure. For more information, see
Figure 10 .
To install a cable management bracket:
1. Unpack the cable management brackets.
2. Attach the cable management bracket to the chassis, and align the screws with the mounting holes
on the chassis, as shown in
Figure 9 .
3. Fasten the screws.
Figure 9 Attaching cable management brackets to an S10508-V
(1) Attach the cable management bracket to the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for attaching the cable management bracket to the chassis
(4) Signal cable management bracket (installed at the upper part of the chassis)
(5) Power cable management bracket (installed at the lower part of the chassis)